Edwards & Co Capsule 2 Series, Инструкция по эксплуатации

Страница: 10 / 20

• Put the shoulder belt around the back of the capsule through the
belt route guides as pictured in Figure 2.
• Tighten the lap belt by pulling hard on the belt. A tight fit is
achieved when the seat has little to no movement when tugged.
• After installation and tightening, the buckle on the passenger seat
should be facing towards the lap belt guides as pictured in Figure
3.
• Check that the seat belts are flat and not twisted.
IMPORTANT
- always check that the seat is installed in a level
position as indicated by the seat level positioner. See the section
“Using the seat level indicator”.
IMPORTANT
– Make sure the capsule is tightly fitted to the vehicle
seat. if the seat does not feel secure, or does not exactly match
these instructions, go back and re-install it. Only once it is properly
secured is it ready to use.
Installing the seat to your car (cont.)
10