Edge PresencePlus P4, Руководство пользователя

Страница: 103 / 182

01/05
P/N 120413
95
User’s Manual Test Tool Setup
Banner Engineering Corp. • Minneapolis, MN USA
www.bannerengineering.com • Tel: 763.544.3164
Tolerance Percent Formula:
Tolerance Percent Example:
-----------------------------------------------------------
Test Tool Results
------------------------------------------------------------------------
-----------------------------------------------------------
Output (default: none)
Choose an available General Output to activate if the Test tool is TRUE.
NOTE: If a discrete output is not available, choose
System in the Main Menu
toolbar, then click on the InputOutput tab. Discrete I/O set up as inputs will
not show up in the Output Options box. See the
System Setup window
(in
Section 12, System Setup
) on page 136 for more information.
Pass/Fail Contribution (default: checked)
-
Check this box if the Test tool will influence the Pass/Fail status of the
inspection.
- Do not check this box if the overall Pass/Fail status of the inspection is not
dependent on the current Test tool.
- The Pass/Fail contribution influences the following:
- Discrete output Pass
- Discrete output Fail
- Pass/Fail results counter
- Pass (Green) and Fail (red) LEDs on the Sensor
- Freezing an image on the video monitor
- Display options on the PC
Max(R) + Min(R)
Max(R) + Min(R)
Toleranced Minimum = Min(R) –
2
x
Tolerance
100
Toleranced Maximum = Max(R) +
x
Tolerance
2 100
( )
( ) The software uses this formula to calculate
each Toleranced Distance , shown previously.
The example at right uses the formula above
and the values entered for Distance (Pixels)
in the MT_1 tab shown previously.
Taught Range = 60 to 80 pixels
Taught Min(R) = 60
Taught Max(R) = 80
Tolerance = 10%
10
10
80 + 60
80 + 60
Toleranced Minimum = 60 –
2
x
100
Toleranced Maximum = 80 +
x
2 100
( )
( )
= 87.00
= 53.00