74
Parameter: [poisoned]
configures split horizon with poison reverse.
Default:
Split horizon with poison reverse
Command Mode:
Interface Mode
Usage Guide:
The split horizon is for preventing the routing loops, namely preventing the layer 3
switch from broadcasting a route at the interface from which the very route is learnt. The
command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example:
Switch#config terminal
Switch(config)#interface Vlan1
Switch(config-if-Vlan1)#ipv6 rip split-horizon poisoned
1.5.3.7 distribute-list
Command:
distribute-list{access-list-name> |prefix<prefix-list-name>} {in|out}
[<ifname>|vlan <vlan-id>]
no distribute-list{access-list-name> |prefix<prefix-list-name>} {in|out}
[<ifname>|vlan <vlan-id>]
Function:
This command uses access-list or prefix-list to filter the route renews messages sent
and received. The “
no distribute-list{access-list-name> |prefix<prefix-list-name>} {in|out}
[<ifname>|vlan <vlan-id>]
” command cancels this filter function.
Parameter:<access-list-name>
is the name or access-list number to be applied.
<prefix-list-name>
is the name of the prefix-list to be applied.
<ifname>
specifies the name of
interface to be applied with route filtering.
Default:
Function disabled by RIPng by default.
Command Mode:
Router mode.
Usage Guide:
The filter will be applied to all interfaces if no specific interface is set.
Example:
Switch#config terminal
Switch(config)#router ipv6 rip
Switch(config-router)#distribute-list prefix myfilter in Vlan1
1.5.3.8 ipv6 router rip
Command: ipv6 router rip
no ipv6 router rip
Function:
Enable RIPng on the interface. The “no ipv6 router rip” command disables RIPng on
the interface.
Default:
Not configured
Command Mode:
Interface Mode
Usage Guide:
The command can configure on IPv6 tunnel interface, but it is successful
configuration to only configure tunnel carefully.