213
Parameter: <ip-address>
: IP address of the neighbor
<TAG>
: Name of peer group
[both|extended|standard]
: Standard community only, extended community or both.
Default:
Sending the community attributes
Command Mode:
BGP route mode and address-family mode.
Usage Guide:
The community attributes can be sent to the outside or not. By default of our
company we set to sending while the default in standard protocol is not sending. By configuring
this attribute community attributes will be carried when sending routing information’s to the
neighbors, or else not. Omission of the following choice will be equal to standard.
Example:
Switch(config-router)#no neighbor 10.1.1.66 send-community
Switch(config-router)#neighbor 10.1.1.66 send-community
1.8.3.66 neighbor shutdown
Command: neighbor {<ip-address>|<TAG>} shutdown
no neighbor {<ip-address>|<TAG>} shutdown
Function:
Disconnect the neighbor connection. The “
no neighbor {<ip-address>|<TAG>}
shutdown
” cancels this configuration
Parameter: <ip-address>
: Neighbor IP address
<TAG>
: Name of peer group
Default:
Not disconnecting
Command Mode:
BGP route mode and address-family mode
Usage Guide:
Directly disconnect/connect to a peer (group) without canceling the neighbor
configuration
Example:
Switch(config-router)#neighbor 10.1.1.64 shutdown
1.8.3.67 neighbor soft-reconfiguration inbound
Command: neighbor {<ip-address>|<TAG>} soft-reconfiguration inbound
no neighbor {<ip-address>|<TAG>} soft-reconfiguration inbound
Function:
Configures whether perform inbound soft reconfiguration; the “
no neighbor
{<ip-address>|<TAG>} soft-reconfiguration inbound
” command set to not perform the
inbound soft reconfiguration
Parameter: <ip-address>
: Neighbor IP address
<TAG>
: Name of peer group
Default:
Not perform inbound soft reconfiguration
Command Mode:
The system saves the inbound messages in the buffer after the soft
reconfiguration is set, will applies as soon as it restarts so to reduce consumptions of switching