Edge-Core ES4524M-PoE, Руководство по управлению, Страница: 430 / 560

Command Line Interface
4-160
4
Example
Related Command
show interfaces switchport (4-145)
Power over Ethernet Commands
The commands in this group control the power that can be delivered to attached
PoE devices through the switch ports.
The switch’s power management enables total switch power and individual port
power to be controlled within a configured power budget. Port power can be
automatically turned on and off for connected devices, and a per-port power priority
can be set so that the switch never exceeds its allocated power budget. When a
device is connected to a switch port, its power requirements are detected by the
switch before power is supplied. If the power required by a device exceeds the
power budget of the port or the whole switch, power is not supplied.
power mainpower maximum allocation
This command defines a power budget for the switch (i.e., the power available to all
switch ports). Use the
no form to restore the default setting.
Syntax
power mainpower maximum allocation watts
watts - The power budget for the switch. (Range: 37-180 watts)
Default Setting
180 watts
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 600
Console(config-if)#
Table 4-11 PoE Commands
Command Group Function Mode Page
power mainpower
maximum allocation
Sets the maximum power available to all switch ports GC 4-160
power inline compatible Provides power to pre-standard PoE devices GC 4-161
power inline Turns power on and off for specific ports IC 4-162
power inline
maximum allocation
Sets the maximum power available to specific switch ports IC 4-163
power inline priority Sets the priority for power supplied to specific ports IC 4-163
show power inline status Displays the current status of power management on specific
ports or all ports
PE 4-164
show power mainpower Displays the current status of power management for switch PE 4-165