Eden HA700, Руководство пользователя

Страница: 14 / 23

14
CHOOSING A MOUNTING LOCATION
The Door/Window Contact Detector is suitable for
mounting in dry interior locations only.
Decide which doors/windows are to be protected by
Door/Window Contact Detectors, (usually the front and
back doors as a minimum will have Door/Window
Contact Detectors fitted). Additional detectors may
also be fitted where required to other vulnerable doors
or windows, (e.g. garage, patio/conservatory doors
etc).
Note: Take care when fixing the Detector to a metal
frame, or mounting within 1m of metalwork (i.e.
radiators, water pipes, etc) as this could affect the radio
range of the device. If required, it may be necessary
to space the magnet and detector away from the metal
surface using a plastic or wooden spacer to achieve
the necessary radio range.
INSTALLING THE DOOR/WINDOW
CONTACT DETECTORS
Ensure that the system is in Test Mode.
1. Undo and remove the fixing screw from the bottom
edge of the Detector. Remove the rear cover.
2. Fit 3 1.5V AAA batteries supplied to the battery
compartment.
3. With the tamper switch not being pressed on the
Detector, detach or close the magnet from the
Detector, the LED on the Detector will illuminate.
4. Using the rear cover as a template, mark the
positions of fixing holes on the fixed part of the
frame along the opening edge opposite the hinges
using screws provided.
5. Refit the Detector to the rear cover and secure with
the fixing screw supplied. Do not over tighten the
fixing screws as this may distort or damage the
casing.
6. Fit the Magnet to the moving part of the
door/window opposite the Detector using the
adhesive tape or 19mm fixing screws.
Ensure that the parallel gap between the Magnet
and Detector is less than 10mm and that the
matching line on the Magnet is pointing towards
and aligned with the line on the Detector.
7. If several windows need to be protected, remove
the self-contained wired supplied and adopt the
wire according to the specifications as mentioned
below. This should be wired to the terminal block
provided in the battery compartment in series
connection. The wired contact should be
connected using two core (24AWG) wire of
maximum length 1.5m.
A cable entry cut-out is available and adjacent to
the terminal block.
SETTING THE DOOR/WINDOW CONTACT
DETECTORS
1. Located on the PCB of the Detector is a
two-position DIP switch (SW2).
2. DIP switches 1-2 are used to enable/disable the
internal or external wired magnetic contact.
Dip Switch(SW2)
Tamper Switch