Eden HA700, Руководство пользователя

Страница: 10 / 23

10
TESTING THE SYSTEM
With the Control Panel in Disarm Mode
Press
User access code
to enter test mode.
1. Trigger each detector on the system by either
walking into a Motion Sensor protected area or
by opening a door/window protected by a
Door/Window Contact detector. As each
detector is triggered the Control Panel will ding
dong to indicate that an alarm signal has been
received.
2. Operate detector tamper switches by opening
the case of the device. As the switches are
operated the Control Panel will ding dong.
3. Activate each button on the Remote Controller in
turn. As each button is pressed the Control
Panel will ding dong.
4. Press 3 seconds on the Control Panel, if
the wireless siren emits one long beep, the
wireless siren enters ‘system off’ mode, which
offers the flexibility of removing or changing
siren’s battery without triggering a full alarm
condition.
Press 3 seconds on the Control Panel, if
the wireless siren emits one long and two short
beeps, the wireless siren enters ‘system on’
mode. A full alarm condition will occur.
To get back to the normal mode, press on the
Control Panel to exit test mode.
MOTION SENSORS
Motion Sensors are designed to detect movement in a
protected area by detecting changes in infra-red
radiation levels caused when a person moves within or
across the devices field of vision. If movement is
detected an alarm signal will be emitted.
Note: Motion Sensors will also detect animals, so
ensure that pets are not permitted access to areas
fitted with Motion Sensors when the system is armed.
The Motion Sensor adopts 3 AA size 1.5V battery
which under normal conditions will have typical life in
excess of 1 year. When the battery level drops, with
the Motion Sensor in normal mode and the rear cover
fitted, the LED behind the detection window will flash
upon detecting movement. When this occurs the
batteries should be replaced as soon as possible.
Note: The adoption of alkaline battery is highly
recommended.
CHOOSING A MOUNTING LOCATION
The Motion Sensor is suitable for mounting in dry
interior locations only.
The recommended position for a Motion Sensor is in
the corner of a room mounted at a height between 1.8
and 2m. At this height, the sensor will have a
maximum range of up to 10m with a field of view of 110
°
, subject to the position for the PCB being set in 1. The
position of the PCB inside the Motion Sensor can be
set to 5 different positions to adjust the range of the
detector. Setting the PCB in position 3 will reduce the
range to 7m approximately, with position 5 providing a
range of 5m approximately. The recommended
position setting for the PCB is in position 1.
110°
10M
U
9 1 3 5 7