Magg™ 480 User Manual
Document: UMDU011367.docm
Revision: A06
Created by: JS
Date: 13 Apr 2021
IPN: 3063241-A06
Source Location: C:\ePDM\ISLEng\Products\DU-MiniMag\Manuals\UMDU011367.docm
Page 7 of 38
User Ma
nual
Safety
In order to be able to use this product properly and safely, every user must first read these operating
instructions and observe the safety instructions contained therein. Take care of these operating
instructions and keep them in a place where they can be accessed by everyone. Untrained personnel
should not handle or operate this equipment.
CAUTION
: Failure to follow these safety instructions may result in injury or
equipment damage.
This system includes some specific devices that have their own User Manuals. Instructions on those
manuals must be also read before using the system.
WARNING:
High Voltage
The tether carries 400
VDC to the rear harness block, and the Minitrac™ whips
carry 400 VDC from the harness block to the tracks. Always Keep the tether
capped when not installed on the vehicle. Follow the guidelines for preventing
tether damage.
400 VDC can cause serious injury or death. Do not operate with a damaged
tether or Minitrac™ whip. Do not operate the system with damaged wires.
Damaged cabling poses a shock hazard. Repair damaged cabling before
operating the vehicle. A short circuit may also damage the controller, cameras, or
any attached equipment.
Disconnect the power source before servicing the product; otherwise, damage or
fatal injury may result.
The power supply is equipped with a ground fault interrupt circuit. Do not cheat or
bypass the ground fault interrupt circuit. Do not power the equipment from a
source other than the Eddyfi Technologies provided power supply.
