MPS-I-0819
Page 2
Page 3
MPS-I-0819
E-SPTS-I-0809
800-638-3326 • edcoinc.com • [email protected]
800-638-3326 • edcoinc.com • [email protected]
EQUIPMENT DEVELOPMENT CO., INC.
EQUIPMENT DEVELOPMENT CO., INC.
Extreme care must be taken when operating
electric models with water present: Ensure power
cord is properly grounded, is attached to a Ground-
Fault-Interrupter (GFI) outlet, and is undamaged.
•
Check all electrical cables - be sure connections are tight
and cable is continuous and in good condition. Be sure
cable is correctly rated for both the operating current and
voltage of this equipment.
•
Engine exhaust from this product contains
chemicals known to the State of California
to cause cancer, birth defects or other re-
productive harm.
•
Tilting a gasoline powered machine fitted
with an EPA approved vented charcoal filter
gas cap, beyond 20° can cause fuel leak-
age. If a leak occurs, do not start or run the engine until
the leak is fixed. Eliminate all other ignition sources in the
immediate area (no smoking, flares, sparks or flames).
Use approved gasoline absorbing material to contain the
fuel leakage. Then use clean, non-sparking tools to collect
absorbed materials then dispose of these contaminants
properly.
•
Gasoline is extremely flammable and poison
-
ous. It should only be dispensed in well ventilated
areas, and with a cool engine.
•
Small gasoline engines produce high concentrations of
carbon monoxide (CO) example: a 5 HP 4 cycle engine
operation in an enclosed 100,000 cu. ft. area with only
one change of air per hour is capable of providing deadly
concentrations of CO in less than fifteen minutes. Five
changes of air in the same area will produce noxious
fumes in less than 30 minutes. Gasoline powered equip-
ment should not be used in enclosed or partially enclosed
areas. Symptoms of CO poisoning include, head-ache,
nausea, weakness, dizziness, visual problems and loss
of consciousness. If symptoms occur - get into fresh air
and seek medical attention immediately.
•
Never refuel a hot engine or an engine while it is running.
•
Engines are shipped from factory without fuel/oil.
SAFETY MESSAGES
Indicates an imminent hazard which, if not
avoided, will result in death or serious injury.
Indicates an imminent hazard which, if not
avoided, can result in death or serious injury.
Indicates hazards which, if not avoided,
could result in serious injury and or damage
to the equipment.
•
Safety Instructions are proceeded by a graphic alert
symbol of DANGER, WARNING, or CAUTION.
ELECTRICAL POWERED EQUIPMENT
GASOLINE / PROPANE POWERED EQUIPMENT
•
Improper connection of the equipment grounding con-
ductor can result in a risk of electric shock. Check with
qualified electrician or service person if there is any doubt
as to whether the outlet is properly grounded. Adhere to
all
local codes and ordinances.
•
NOTE:
In the event of a malfunction or breakdown,
grounding provides a path of least resistance for the
electric current to dissipate. The motor is equipped with
a grounded plug and must be connected to an outlet that
is properly installed and properly grounded. DO NOT
modify the plug provided on the motor. If the plug does
not fit the outlet have a qualified electrician install the
proper receptacle.
•
Do not disconnect power by pulling cord. To disconnect,
grasp the plug, not the cord.
•
Unplug power cord at the machine when not in use and
before servicing.
•
Switch motor OFF
before
disconnecting power.
•
Never use frayed, damaged, taped or under rated exten-
sion cords. Electrical shock could result in death or seri-
ous injury to the operator and damage to the equipment.
•
Assure you are using the proper extension cord length.
•
Propane is extremely flammable and is heavier
than air and tends to settle in low areas where a
spark or flame could ignite gas. DO NOT start or
operate this propane engine in a poorly ventilated area
where leaking propane gas could accumulate and endan-
ger safety of persons in area. If headache develops, shut
off machine. Have it checked for carbon monoxide emis
-
sions by a qualified technician before using it again. To
ensure personal safety, installation and repair of propane
fuel supply systems must be performed only by qualified
technicians. Carbon monoxide emissions from this machine
are greatly increased due to a dirty combustion air cleaner.
PROPANE POWERED EQUIPMENT CONTINUED
SAFETY INFORMATION