ECS Photon Extreme KN3 SLI2, Руководство пользователя, Страница: 33 / 106

3-4
IDE Channel 0 Master/Slave(None)
Leave this item at Auto to enable the system to automatically detect and
configure IDE devices on the channel. If it fails to find a device, change the
value to Manual and then manually configure the drive by entering the
characteristics of the drive in the items described below.
Note: Before attempting to configure a hard disk drive, ensure that you have the
configuration information supplied by the manufacturer of your hard drive.
Incorrect settings can result in your system not recognizing the installed hard
disk.
Access Mode
This item defines ways that can be used to access IDE hard disks such as LBA
(Large Block Addressing). Leave this value at Auto and the system will automatically
decide the fastest way to access the hard disk drive.
Press <Esc> to return to the Standard CMOS Features page.
Drive A(1.44M, 3.5in.)
This item defines the characteristics of any diskette drive attached to the system.
IDE HDD Auto-Detection
Press <Enter> while this item is highlighted to prompt the Setup Utility to automatically
detect and configure an IDE device on the IDE channel.
Note: If you are setting up a new hard disk drive that supports LBA mode, more than one
line will appear in the parameter box. Choose that lists LBA for an LBA drive.
3.3-2 Advanced BIOS Features
This option defines advanced information about your system.
Phoenix-Award WorkstationBIOS CMOS Setup Utility
Advanced BIOS Features
Base Memory, Extended Memory and Total Memory
These items are automatically detected by the system at start up time. These are
display-only fields. You cannot make chanages to these fields.
Halt On (All, But Keyboard)
This item defines the operation of the system POST (Power On Self Test) routine.
You can use this item to select which types of errors in the POST are sufficient to
halt the system.
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Removable Device Priority [Press Enter]
Hard Disk Boot Priority [Press Enter]
CPU Internal Cache [Enabled]
External Cache [Enabled]
Quick Power On Self Test [Enabled]
First Boot Device [Removable]
Second Boot Device [Hard Disk]
Third Boot Device [CDROM]
Boot Other Device [Enabled]
Boot Up Floppy Seek [Disabled
Boot Up NumLock Status [On]
Gate A20 Option [Fast]
ATA 66/100 IDE Cable Msg. [Enabled]
Typematic Rate Setting
[Disabled]
Typematic Rate (Chars/Sec0 6
Typematic Delay (Msec)
250
Security Option [Setup]
APIC Mode [Enabled]
Item Help
Menu Level
CPU Feature [Press Enter]
X
X
1
1
1
1