ECR International ENVIROair PTAC Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 12 / 16

INSTALLATION
HOW TO INSTALL THE UNIT
!
CAUTION
There are sharp edges that can cause serious cuts.
When lifting the air conditioner,it is HEAVY.Use 2
people to lift.
- For existing sleeve,you should measure the wall
sleeve dimensions.
- Install the new air conditioner according to these
Shipping
tape
- Then lift up .
WALL
WALL
Fig.2
SLEEVE
HEAT
RADIATION
Over 20
408mm/16inch
1067mm/42inch
606mm/23.9inch
408mm/16inch
376mm/14.8inch
1067mm/42inch
installation instructions to achieve the best
performance. All wall sleeves used to mount the new
air conditioner must be in good structural condition
and have a rear grille that securely attaches to the
sleeve or the flange of the sleeve to secure the new
air conditioner.
-To avoid vibration and noise,make sure the unit is
installed securely and firmly.
- When installing the sleeve,make certain there is
nothing within 20 of the back that would interfere
with heat radiation and exhaust air flow. (See Fig.2)
COOLED
AIR
INTAKE
AIR
PREPARATION OF SLEEVE ASSEMBLY(optional)
- Refer to the installation instruction of sleeve assembly for
details.
PREPARATION OF REAR GRILLE ASSEMBLY(optional)
- Refer to the installation instruction of rear grille assembly
for details.
UNIT INSTALLATION
- Carefully remove shipping tapes from the front panel.
(See Fig.3)
- Remove the front panel. (See Fig.4)
- Remove the shipping screw from the vent door. (See Fig.5)
11
Dimension of air conditioner
Dimension of sleeve assembly (optional)
Fig.3
-
Pull out at the bottom to release it from the tabs .
Fig.4
Shipping
screw
Fig.5