ECR International ENVIROair PTAC Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 14 / 16

CARE AND CLEANING
!
CAUTION
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damge or improper operation. Airflow restriction may
cause damage to the unit.
AIR FILTERS
IMPORTANT:TURN UNIT OFF BEFORE
CLEANING.
!
CAUTION
UNIT DAMAGE HAZARD
Failure to follow this caution may result in
equipment damge or improper operation.
Do not
operate unit without filters in place.If a filter
becomes torn or damaged,it should be replaced
immediately.
Operating without filters in place or with damaged
filter will allow dirt and dust to reach indoor coil and
reduce cooling,heating,airflow and efficiency of unit.
Airflow restriction may cause damage to unit.
- The most important thing you can do to maintain
unit efficiency is to clean the filters once every
two weeks as required.
Clogged filters reduce cooling,heating and airflow.
Pull up
2 Air filters
Screws
control lever
Fig.11 Vent door
FRONT PANEL AND CASE
- Turn unit off and disconnect power supply.To clean,
use water and a mild detergent. use bleach DO NOT
and abrasivers.Some commercial cleaners may
damage the plastic parts.
OUTDOOR COIL
- Coil on outdoor side of unit should be checked
regularly.Unit will need to be removed to inspect
dirt build-up that will occur on the inside of the
coil. If clogged with dirt and soot ,coil should be
professionally cleaned.Clean inside and outside of
outdoor coils regularly.
NOTE: Never use a high-pressure spray on coil.
- Keeping filters clean will:
Decrease cost of operation.
Save energy.
Prevent clogged indoor coil.
Reduce risk of premature component failure.
-
To Clean Air Filters:
Vacuum off heavy soil.
Run water through filter.
Dry thoroughly before replacing.
13
- Removing Air Filter
Fig.9
- Replacing Air Filter
Push down
Fig.10
VENT DOOR FILTER
IMPORTANT:TURN UNIT OFF
BEFORE CLEANING.
- If vent door is open, access requires removal of the
unit from the wall sleeve. Clean vent filter twice a
year or as required.
- Make sure to remove the shipping screw from the
vent door.(See Fig.5)
- Rotate vent control lever to open vent door.(See
Fig.6)
- Remove four screws from the vent door filter.
(See Fig.11)
- First pull out vent door steel wire from the hole of
the vent door, then take off the vent door and filter.
(See Fig.11)
- Clean the filter. Dry thoroughly before replacing.
- Replac e the vent door and filter,reinstall the four
screws.
- Reinsert the vent door steel wire into the hole of the
vent door.
Vent door
Vent door
steel wire
Vent door
filter