Ecosoft Robust, Инструкция по установке и эксплуатации

Страница: 13 / 28

Instruction manual for ECOSOFT Robust reverse osmosis system | 13
This manual is the intellectual property of, and copyrighted by ECOSOFT SPC LLC. Copying and reprinting is forbidden. © 2015
7.4 blue tube, then put on ferrule and put
insert inside the tube.
Push the end of blue tube inside the shank bottom a few centimeter deep, seat
the ferrule against shank bottom and screw compression nut snugly on shank
thread. The faucet should now be firmly fixed on top of sink, and blue tube tightly
seated in compression fitting at the bottom of faucet shank.
8 Remove 1
st
and 2
nd
prefilter housings (left to right), put the polypropylene filter in
the first bowl, carbon filter in the second.
9 Install the housings back on the system frame. Hand tighten only.
10 Prepare a suitable water container. Remove feed water tubes from the two first
stage membrane housings and place the free ends in the prepared container.
Open main shutoff valve and the system’s feed valve to start rinsing prefilters.
Collect running water in the container and discard when full. Repeat until there
are no carbon fines in rinsewater. Install the free tube ends back in push-fit
fittings in membrane housings and lock with locking clips.
11 Install carbon postfilter in 3
rd
filter housing from the left.
12 Install three membranes in membrane
housings.
Caution!
When installing reverse osmotic
membrane, do not take it out of the bag.
Cut the bag at the opposite end to
membrane’s brine seal, push the
membrane inside membrane housing. Do
not touch membrane surface at any time.
13 Open feed valve and
purified water faucet
for 30 minutes to rinse
membranes and other
parts of the system. Do
not open tank valve at
this time. Close the
purified water faucet and check all connections for leaks.
Caution! Inspect the system for leaks every day for the first week after
installation. Continue to check periodically onward. When leaving for an extended
while, shut off main valve to remove water supply to the system.
14* Open tank valve and let the system fill it. The system will switch off when tank is
full. Open purified water faucet and discard the first tankful of purified water.
When the tank is drained empty, close the purified water faucet and let the
system refill the tank. The water can be used now.
* Skip steps 6 and 14 if installing a tankless system.