13
START UP CHECKLIST
After completing the preceding installation and programming steps, check all the fol-
lowing:
D
Make sure the bypass valve(s) are in the “service” postion.
D
Check for leaks.
D
Open a filtered water faucet and confirm that the air pump runs. Pump will run for
8 seconds after water flow has stoped.
D
Make sure the ball valve on the neck adaptor is open. See Figure 10.
D
Make sure the solenoid vent is open when the air pump is running.
D
Make sure the vent tube is held securely at the drain point. Air/water mixture
exits the vent tube with force. Observe the vent tube for at least 10 minutes while
air pump is running and solenoid is open to ensure that vent tube is held se-
curely and will not become dislodged from the drain.
FIGURE 10
Ball Valve
Open
Ball Valve
Closed
