19
DOOR CATCH
Should the door catch require adjustment, please
follow the procedure below:
Open the Door. Slacken the M6 grub screw, on the
underside of the Handle Boss. Turn the inside catch
shaft one turn clockwise, this will achieve a tighter
lock when the door is closed. Re-tighten the M6
grub screw. Close and test the operation of the
Handle mechanism.
ROPE
Check the 12mm rope around the door. If rope is
becoming detached, use Eco Ideal Stoves rope glue
to reattach it. If the rope is in a poor condition, a
replacement rope kit may be ordered from the Eco
Ideal Stoves spares range.
CHIMNEY & FLUE WAYS
It is important that the chimney, flue ways and any
connecting flue pipe are swept regularly. This means
at least once a year for smokeless fuels and at least
twice a year for wood and other fuels.
The baffle will need to be removed from its supports
in order to sweep the chimney. Only wire-centred
sweeps’ brushes fitted with a guide wheel should be
used. If it is not possible to sweep all parts of the
chimney through the appliance, ensure there is
adequate access to cleaning doors. If the stove is
fitted in place of an open fire, then the chimney
should be swept one month after installation to
clear any soot falls which may have occurred due to
the difference in combustion between the stove and
the open fire.
SEASONAL USE
If the appliance has been unused for a long period of
time, such as during the spring and summer months,
the chimney should be checked for potential
obstructions by a competent person before lighting
the stove.
DE-ASHING
De-ashing should be carried out on a regular basis to
avoid a buildup of ash and ensure sufficient primary
air flow. Empty the ashpan regularly to prevent ash
reaching the underside of the great bars.
ANNUAL SERVICE
Eco Ideal Stoves recommend that this appliance is
serviced annually, preferably prior to the start of the
heating season, thus avoiding any delay in receiving
replacement components, should you need them. I
you feel unable to undertake this task, Eco Ideal
Stoves recommend that you contact the installation
engineer for advice.
Remove all the internal components:
Riddling Bars, Cam Bar, Catch Bar, Ashpan, Side
Plates and Baffle. Clean them with a wire brush and
inspect them for damage.
Sweep the chimney/flue system if necessary.
Clean down the internal surfaces of the appliance
using a scraper or wire brush.
Inspect these surfaces for damage/corrosion.
If corrosion or damage is found we advise that you
consult with your installer about rectification/repair.
Brush out or vacuum the inside of the appliance and
re-fit the internal components.
Inspect the Glass and Gasket. Clean the Glass with a
non-abrasive cleaner if required. If the Gasket is
torn or damaged we recommend that is replaced to
ensure that no products of combustion enters the
room when the appliance is used.
Brush down the outer surface and touch up the
paint if necessary.
Burn the appliance at a low rate, after maintenance,
to allow any new seals, paint or glue cure properly.
The appliance may emit unpleasant odours during
this process, please ensure the room is well
ventilated.
Содержание eco 4
Страница 22: ...22 Body Assembly Spares...
