21
Appendix B: Module Stand-alone Mode and EIB Mode
CAN data from LambdaCAN* modules can either be taken directly from the modules
themselves or from the CAN port of display heads connected to the modules. When data is
taken directly from one or more modules, each module must in Stand-alone mode. When
data is taken from one or more display heads of a Lambda 5220, or EGR 5230 analyzer, each
module must be in EIB mode.
Therefore, the module must be properly configured in Stand-alone mode or EIB mode
depending on how it will be used. When LambdaCAN* modules are sold alone, they are
delivered in Stand-alone mode. When LambdaCAN* modules are sold as part of a Lambda
5220 or EGR 5230 analyzer, they are delivered in EIB mode.
To convert from one mode to the other requires software reprogramming of the module
followed by the installation (to set to Stand-alone) or removal (to set to EIB) of a jumper
inside the module.
To convert a module from EIB to Stand-alone Mode
1. Take the nut off the end of the module. Use an 18mm socket without the wrench.
2.
Release the two tangs at each side of the module.
Содержание LambdaCAN Series
Страница 22: ...18 Appendix A LambdaCAN Kit Contents P N 12 02 P N 10 35 LambdaCANp only P N 10 04 LambdaCAN LambdaCANd only...
Страница 48: ...44...
Страница 49: ......
Страница 50: ...Los Altos CA 94023 0040 USA 408 734 3433 Fax 408 734 3432 www ecm co com...