ENGLISH
Translation of the German original user manual
29
2.
Put the blind filter into the portafilter.
3.
Pour ½ spoon of detergent into the blind filter or put a tablet into the portafilter.
4.
Place the portafilter in the group head.
5.
Operate the group lever for approx.. 20 seconds. The blind filter will fill with water.
6.
Let the detergent react, moving the group lever into the middle position. (approx. 45°; Do not move it into
the lower position.)
7.
Move the lever into the lower position after approx. 20 seconds. This way, the fats and oils can be
discharged by the infusion cylinder.
8.
Repeat points 5-7 several times, until only clear water is discharged by the infusion cylinder.
9.
Rinse the portafilter and the blind filter with fresh water. Then replace it.
10.
Operate the group lever for approx. one minute. Then move it back into the lower position.
11.
Remove the portafilter and repeat point 10. After this, the brew group is ready for use.
12.
Exchange the blind filter for the coffee filter
Caution!
Beware of hot sprayings while cleaning the group.
(danger of injury)
.
In case you programmed the cleaning mode, the“CLn” will disappear on the display after
having operated the brew group lever 10 times. The counter will then restart until the next
cleaning advice.
How to program the group cleaning mode see 6.3.4
If you clean the brew group to often with cleaner, it may start squeaking. Don´t clean it to
often with cleaner, you will degrease all the moving parts and they will wear out quickly. It´s
better if you clean the brew group from time to time without cleaner.
Empty the water drip tray regularly and do not wait until it is full in case the machine is not directly hooked up
to a water drainage.
7.3 Maintenance
Vorsicht!
Make sure that the machine is disconnected from the power supply during maintenance and
when replacing parts.
Replacing the group gasket and the shower screen
1.
Switch off the machine (power switch in lower position) and disconnect the power cord.
2.
Open the steam valve and release the steam. Then close it again.
3.
Let the machine cool down to room temperature.
Follow the steps as indicated below:
1.
Brew group in the beginning.
2.
Use a flat screwdriver to pry out
the shower screen and the group
gasket.
3.
The shower screen and the
gasket are now nearly removed.
