Eclipse EC-P50, Руководство по установке

Страница: 13 / 52

P0016-LI-03.01 13
External Sounder/Strobe Connections
The following connections are available for connection to an
external sounder/strobe unit:
TR
Tamper Return input. Connect to the tamper output on the
external sounder/strobe unit. If this input is not used it must be
linked to 0V.
0V
0V supply. Connect to the 0V (-) supply on the external
sounder/strobe unit.
+12
Positive 12V supply, which is protected by an auto resetting fuse
(PTC) rated at 1.1A. Connect to the +12V (+) supply on the
external sounder/strobe unit.
Bell (1)
Panel output 1 is pre-configured for Bell operation, i.e. it switches
to 0V when active. Connect this terminal to the bell trigger input
on the external sounder/strobe unit. The output can be inverted
for SCB operation, see page 30 for details.
Strobe (2)
Panel output 2 is pre-configured for Strobe operation, i.e., it
switches to 0V when active. Connect this terminal to the strobe
input on the external sounder/strobe unit.
Control Panel
12V
TR
0V
12
External Sounder
Tamper
0V
+12V Suppy
Bell -ve
Strobe -ve
Panel Outputs 1 - 5
The control panel has five programmable outputs, which can be
used to drive auxiliary devices such as LEDs, sounders or relays
etc. (see page 30 for details on programming outputs). Each
panel output is rated at 1 Amp and switches to 0V when active.
The figure bellow shows some wiring examples:
Control Panel
OP
12V
Relay Driver
+
-
12V Relay
Control Panel
OP
12V
1K
cathode
anode
LED Indicator
LED
Control Panel
OP
12V
Buzzer Driver
+
-
12V Buzzer
2-Wire Smoke Detectors
A maximum of 10, 12V 2-wire smoke detectors can be connected
to the control panel using panel output 5. The detectors must be
connected as shown below. The Enable 2-wire jumper link must
be set as shown and the output must be programmed for “2-wire
Smoke” (0047) operation, see page 30 for details.
A Maximum of 10 2-Wire Smoke Detectors
can be connected to panel output 5
Control Panel
5
12V
V In
0V
V Out
V In
0V
V Out
E.O.L
1K