EW28650 User’s Manual
rev. 3/14
EW28650: In-wall Wireless Access Point
32
3-4-2
Logout
If you would like to leave the configuration page, please click Apply to exit.
Figure 23 Logout Screen
Appendix A Signal Connection Arrangements
RJ-45 Ethernet Port
The In-wall Access Point RJ-45 Ethernet port can connect to any networking devices that use a
standard LAN interface, such as a Hub/Switch or Router. Use unshielded twisted-pair (UTP) or shielded
twisted-pair (STP) cable to connect the networking device to the RJ-45 Ethernet port.
Depending on the type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as
prescribed.
10Mbps:
Use EIA/TIA-568-100-Category 3, 4 or 5 cables.
100Mbps:
Use EIA/TIA-568-100-Category 5 cable.
Figure 24 RJ-45 Connector and Cable Pins
Note:
To prevent loss of signal, make sure that the length of any twisted-pair connection does not
exceed 100 meters (approximately 328 feet).
