28
Installation Guide
28
tel - 1-866-766-2267
email - [email protected]
Illustrations are typical and may not match exact vehicle detail
FCTP-GM2403
Trailering Camera System
Module Assembly and Installation (continued)
Step 1:
Before turning the ignition to the ON position for the first time
after the installation is finished, re-conenct the battery if it
was disconnected at the beginning of the install. Then, make
certain that the LEDs at the top of the module have stopped
flashing. Failure to do this will render the touch screen
unresponsive. If you find that this step was not completed and
the touch screen is unresponsive, turn the vehicle’s ignition
to the OFF position and wait until the LEDs have stopped
flashing, then turn the vehicle’s ignition to the ON position.
Step 2:
Once the radio finishes the boot
up sequence, press and hold the
HOME button for 3 seconds. The
WARNING screen will appear.
Press the OK button.
Testing & Setup
Step 10:
Place the GMS4 mounting bracket onto the vehicle’s
plastic Multifunction Power Supply Converter Bracket
bracket according to the picture. Make sure that the C
portion of the mounting bracket clips all the way around
the plastic factory bracket. Reinstall and tighten the 10mm
retaining nut.
If the battery was disconnected at the beginning
of the install, ensure it is re-connected before
attempting to turn on the vehicle to test the system.
NOTE
