echoflex MC-31, Руководство по установке

Страница: 4 / 12

Echoflex Installation Guide
Magnetic Contact Sensor
Magnetic Contact Sensor (MC-31) Page 4 of 12 Echoflex
The battery can be replaced while the sensor is in its mounted position.
To replace the battery:
1. Insert a screwdriver
into the slot and gently
pry to open the tray.
2. Insert the new battery
in the tray with the
positive side (+) up.
3. Close the battery tray
and press the
[Teach]
button to test. The blue LED blinks to confirm success.
Estimated battery life is up to 10 years based on an average of 10 operations
per day. Configuration settings that require many transmissions affect the
life of the battery.
Tests and Settings
The
[Teach]
button and color LEDs are used to navigate the Tests and
Settings Menu. The intervals between blinks make it easy to distinguish
between single, double, and triple-blinks.
•
Exit and Start Over
(green single blink LED)
•
Range Confirmation Test
(blue single blink LED)
•
Magnet Position Test
(red single blink LED)
•
LED Display
(green double-blink LED)
•
EEP Select
(blue double-blink LED)
•
Operating Mode
(red double-blink LED)
•
Heartbeat Messaging
(green triple-blink LED)
•
Energy Status Messaging
(blue triple-blink LED)
•
Redundant Messaging
(red triple-blink LED)
•
Restore Defaults
(blue, then red, then blue triple-blink LED)
The menu times out after two minutes of inactivity.
Note:
A combination of green, blue, and red LEDs creates a
white LED color. The white LED blinks twice to confirm
a selection.
LED
Teach
button
Battery
(CR2032)
Slot to open tray