echoflex MC-31, Руководство по установке

Страница: 6 / 12

Echoflex Installation Guide
Magnetic Contact Sensor
Magnetic Contact Sensor (MC-31) Page 6 of 12 Echoflex
Magnet Position Test
The Magnet Position Test uses a red blinking LED to indicate whether the
magnet is properly positioned to be detected by the sensor. The LED
indication for this test operates even if the
LED Display
setting is disabled.
1. Press and hold the
[Teach]
button until the white LED blinks twice.
2. Press and release the
[Teach]
button to cycle through the menu of
color LEDs and stop when the red LED blinks once.
3. Press and hold the
[Teach]
button until the white LED blinks twice to
initiate the Magnet Position Test.
• Rapid red LED blinks indicate the magnet is in range
• No LED if out of range
To exit before time-out, press and hold the
[Teach]
button until the white
LED blinks twice.
LED Display
During normal operation, a green LED blinks to indicate a contact open
event and a red LED blinks to indicate a contact close event. The LED Display
setting controls whether the operating mode LEDs are enabled or disabled.
Disabling the LEDs eliminates distractions as well as conserves battery
power. The LEDs still operate to run tests and indicate low battery even if
the display is disabled.
1. Press and hold the
[Teach]
button until the white LED blinks twice.
2. Press and release the
[Teach]
button to cycle through the menu of
color LEDs and stop when the green LED double-blinks.
3. Press and hold the
[Teach]
button until the white LED blinks twice to
select LED Display.
The green LED blink code displays the current setting. Press and release
the
[Teach]
button to navigate the options.
4. Press and hold the
[Teach]
button until the white LED blinks twice
when the target indication displays. The MC-31 saves the setting and
then restarts.
Indication Setting
1 green blink Disabled: no LED blink
2 green blinks Enabled: LED blink on contact (default)