10
CSG-670 TYPE1-E
Prim Use
General purpose mild and
stainless steel: re-bar, pipe
and structural steel
Ductile or cast Iron and
concrete lined pipe
Heat treated, wear hardened
and alloyed steel
All masonry, concrete and
stone products and asphalt
Rock, block, stone, tile
Engine Drive Pully
10000 r/min ± 500 r/min
= between 4750 and
5250 r/min
Wheel Speed
ABRASIVE WHEEL TYPES AND USES
ECHO Wheels are labeled for the type of materials they are designed to cut. The types of wheels
identified below, and other types, may be available from ECHO dealer.
Labeled Application
Metal
Ductile
Rail Track
Masonry
Diamond Wheel
Other Uses
Aluminum and soft
brass. Does not cut
non-metals very well
AII except very hard
metals
Not for non-metals
Not for metals
Not for metal or
reinforced concrete
ECHO REINFORCED WHEELS WHEEL SPEED RATING
The speed rating printed on these reinforced wheels could range from 6000
to 6300 r/min. This is the minimum acceptable wheel speed rating for this
unit. Wheels rated less than 6000 r/min must not be used on this saw.
Read Label on the
Wheel
MAXIMUM ALLOWABLE WHEEL SPEED
The wheel rotates at the same speed as the spindle (arbor) on which it is
mounted. The wheel must never be allowed to rotate faster than 6000 r/min
if the wheel speed is rated at 6000 r/min. (See “Engine Speed and Wheel
Speed”, below.)
ENGINE SPEED AND WHEEL SPEED
Since the reduction ratio of the engine drive pulley to the large driven pulley
is about 2 to 1, the wheel speed will be half whatever the engine drive pulley
speed is.
The unit has a governor system designed to govern the engine high speed,
at no load, to within 500 r/min of 10000 r/min, at which the wheel speed
should range between 4750 and 5250 r/min. – safety inside the 6000 r/min
limit. If the engine exceeds this speed limit, take it to your nearest ECHO
servicing dealer for service.
Dry or Water Flush
Dry
Dry. Does not cut
well when wet
Dry
Constant Water
Flush or Dry
Dry
