15
CSG-670 TYPE1-E
STARTING AND STOPPING
SAFE STARTING TECHNIQUES
IMPORTANT
z
Check unit for loose nuts, bolts and screws before starting.
z
Always clear work area of debris before starting operation.
z
Always hold the unit firmly.
z
When pulling starting rope, use short pulls, 1/2 to 2/3 of rope length.
z
Do not allow the starter grip to snap back against the housing.
Set saw down on level ground with wheel or saw blade in the clear. Grasp
front handle with left hand, and hold down rear handle with toe of your boot.
Never “drop-start” the saw.
WARNING
Wheel will rotate when engine is started at latched throttle setting.
Keep cutting wheel in the clear.
STARTING COLD ENGINE
1. Pull out choke all the way.
2. Move ignition switch to “RUN” position.
3. Depress and hold throttle trigger and lockout
while pushing in latch button to latch throttle for
starting.
4. Crank engine. Pull starter grip briskly, but only
1/2 to 2/3 its full length. Pulling rope to the end
may damage the starter.
5. Push in the choke the first time engine fires, and
crank until engine starts and runs. In cold
weather you should keep the choke out just a
little until the engine gets very warm. But, do not
operate with the choke out.
6. Squeeze and release trigger when engine runs.
You now have trigger control of the throttle
speed.
3
Depress and Hold
Both Throttle Trigger
and Lockout Lever,
and Push in Latch
Button, then Release
Trigger
1
Pull out Choke
2
Move Switch to “RUN”
6
To De-latch Throttle,
Squeeze and Release
the Trigger
4
Pull Starter Grip
