Echo 9 Ultra H2, Руководство по эксплуатации

Страница: 31 / 36

31
6
Once new filter is installed
,
the filter replace light is no
longer flashing.
7
Flush out the carbon dust.
8
Replace the filter housing cover.
-The water will initially come out discolored (light to charcoal
gray) due to carbon particulates in the new filter.
This is not harmful.
Allow the water to flow for 2-3 minutes in the "H
2
Water" mode
and this will flush all the carbon dust.
5
Once new filter is installed, rotate the filter until the arrow on the filter is aligned
with the arrow on the machine.
Your Echo
®
filter is equipped with a genomic chip. This chip communicates with
the machine how much water has flowed through the filter.
4
Insert the new filter into the compartment.
Remove the plastic caps covering both ends of the new filter.
Set the large opening (on the bottom of the filter cartridge)
onto the base in the center of the filter cushion.
Push the filter down and into the housing compartment
ensuring the opening at the top of the filter is seated
properly into the fitting, at the top of the housing.
Change filter with the same as method above.
A
A
B
B
Check for leakage by running water through
your machine BEFORE replacing the housing cover.
A
Echo
®
9 Ultra Replacement Filter
B
H
2
Water Replacement Filter
Make sure the arrow on
filter lines up with the
arrow on the machine!
★