TDS-100M Manual
10
AI5
setup
53
display analogue input AI5(reserved for the TDS16 mainboard)
54
Setup of OCT totaliser pulse output,pulse width,range:6 Ms-1000Ms.
55
choose current loop mode
56
corresponding data to output of current loop 4mA or 0mA
57
corresponding data to output of current loop 20mA
58
Verification of current loop output.applied to check whether current loop is normal or
not.
59
present output of current loop
60
Date time and setup.the date time of the new flow meter is realized by CPU,when
upgrading software,time will be slow,so after upgrading,recommend to adjust the date
and time to display correctly
61
Software version information and Electronic Serial Number (ESN)
62
setup serial port parameter
63
Communication protocol choosing(including compatible protocol choosing),two
options,choosing MODBUS-RTU means using binary system MODUS-RTU
protocol.choosing MODBUS-ASCII+previous protocol means using ASCII protocol,at
this
time can
support several protocols simultaneously,including
MOSBUS-ASCII,previous 7 version protocol,FUJI protocol,Meter-BUSx protocol etc.
64
analogue input AI3
65
Analogue input AI4
66
Analogue input AI5
By inputing measuring range ,the flow meter will turn
current signal into data range users need,so display
related analogue input that corresponding to physical
parameter data.
67
Setup frequency range of frequency output signal.frequency signal output represent
instant flow rate value by signal frequency value.default:0-1000Hz
，
max-range:0-999Hz.output frequency signal by special frequency output unit.
68
setup lower limit flow of frequency signal output
69
setup upper limit flow of frequency signal output
70
LCD backlit control
71
LCD contrast ratio control
72
Work timer,logging work time of the meter by unit of second.it can reset.
73
setup lower limit flow of
frequency signal output
74
setup upper limit flow of
frequency signal output
75
LCD backlit control
76
LCD contrast ratio control
by setuping the lower and upper limit of alarm,confirm a
range,when actual flow is over the range set in this
window,then create a alarm signal output.alarm signal
can be transferred to outside by setuping OCT or relay.
77
beeper setup options
78
setup Open Collector Transistor output(OCT) output options
input
and
output
setup
79
setup relay(OCT2) output options
80
choose input signal of batch controller
81
batch
controller
