10
2.1
Hard disk and DVD-RW Installation
2.1.1 SATA
Port
y
Main substrate of this DVR has three SATA ports: they are indicated as SATA 1,2 and SATA 3.(
A Type
)
Main substrate of this DVR has four SATA ports: they are indicated as SATA 1,2 and SATA 3,4.(
B Type
)
y
Up to two SATA devices (hard disk and DVD-RW) are connected in Serial to the SATA ports, but the devices must be
connected correct SATA port.
y
Please mount DVD-RW at the
SATA 3 port.
(
A Type
DVR)
Please mount DVD-RW at the
SATA 4 port.
(
B Type
DVR)
y
Refer to below table to mount a hard disk and DVD-RW.
A Type
Storage
SATA 1,2 Port
SATA 3 Port
HDD DVD-RW
1
2
3
1 1
HDD ----
DVD-RW
A Type 4/8/16
Channel DVR
2 1
HDD HDD
DVD-RW
B Type
Storage SATA
1,2
Port SATA
3,4
Port
HDD DVD-RW
1
2
3
4
1 1
HDD ---- ---- DVD-RW
2 1
HDD HDD ---- DVD-RW
B Type 4/8/16
Channel DVR
3 1
HDD HDD HDD DVD-RW
2.1.2
No Jumper Designation
y
SATA device does not use jumper. You only need to connect SATA device to SATA port according to HDD/ DVD-RW you
have. A connector for designation is located between the 7-pin SATA connector and the 15-pin Power connector.
2.1.3 HDD
Installation
y
Securely fix a hard disk by using bracket and screws provided herewith.
y
Please do not use any different hard disk cables (data cable and power supply cable) other than ones we provide.
Otherwise, it may cause damage to the hard disk.
CAUTION
y
For installation/addition/replacement/Removal of HDD (DVD-RW), make sure that DVR is turned off. Otherwise, it may cause
permanent damage to the HDD (DVD-RW).
y
Installation/Addition/Moving/Replacement:
You should start ‘HDD initialization’ including formatting. Otherwise, DVR won’t
recognize the hard disk and may begin to function abnormally. Please follow the below procedure for ‘HDD initialization’.
①
(Date/Time setup) Set up the current date and time (SETUP>SYSTEM>Admin>Date/Time)
②
(Initialization of system setup) All values in setup are restored to factory default settings
(SETUP>SYSTEM>Information>Status>Setup>Default).
③
(HDD format) HDD format is done by SETUP>SYSTEM>Admin>Storage>Format. If there are more than two HDDs, each must
be formatted, separately. When the format is completed, DVR will auto-reboot.
y
Removal:
Follow the Remove procedure even when a pre-installed hard disk has been removed. In
SETUP>SYSTEM>Admin>Storage>Format, click (
) ‘Removed’ item under the discrete Format headings of a corresponding
HDD to discard ‘HDD’ item. When the Remove procedure is completed, DVR will auto-reboot.
CAUTION
Install hard disk after DVR power is off. Otherwise, it may cause permanent damage to the hard disk. To turn off DVR, please click (
)
SETUP>SYSTEM>Shutdown. Also, wait for 5 seconds before plugging in power supply again.
2. Installation
Содержание E0824
Страница 10: ...9 B Type 4 8 16 Channel Series DVR...
