580/03.05.23/V2
P a g e |
14
of 29
Ecco Stove | Foster House | 2 Redditch Road | Studley | B80 7AX | United Kingdom
T
| +44 (0) 1527 857 814
E
W
| www.eccostove.com
For all patents
–
See Addendum
High temperature hot face linings are suitable but not above 225 x 225 in
section.
It is advisable not to connect the Ecco Stove 580EC2 to clay linings within
chimneys, unless those clay linings have a hot face liner fitted within, in
order to reduce condensation within the chimney flue.
Heat expansion joint
–
As metal expands at a different rate to Silicon
Carbide an expansion joint needs to be in place around the flue pipe
where it connects into the stove. Failure to do so may result in cracks
around the connection which would not be covered by the guarantee.
This can be achieved with a flat ceramic glass tape rope seal.
ANY FLUE INTENDED FOR USE MUST BE SWEPT IN ADVANCE AND TESTED FOR SUITABILITY
PRIOR TO THE APPLIANCE BEING INSTALLED. IF INSTALLINGTHIS STOVE ONTO AN
EXISTING FLUE WHICH IS DEEMED/TESTED AS SUITABLE WHICH WAS PREVIOUSLY USED
FOR AN OPEN FIRE, THE FLUE MUST BE SWEPT AGAIN WITHIN A MONTH OF INSTALLATION
AS THE HIGHER TEMPERATURE OF FLUE GASES MAY LOOSEN THE OLD OPEN FIRES BUILT
UP DEPOSITS, TO ENSURE BLOCKAGE DOESN
’T OCCUR.
19.
CLEANING AND MAINTENANCE
The Ecco Stove 580EC2 under top flue way must be cleaned at least twice in a burning
season. Access must be left in the stoves pipe within 200mm of the stoves top and brushed
forward into the stove under top flue way from there.
-
Seasonal Use
-
Repairs or replacements must be carried out by a competent engineer.
-
Ensure the flue way accessed through the stove pipes cleaning door (within 200mm of
the stoves top) is brushed or vacuumed out
-
Check that the flue off the stoves top (including the flue lining throughout) is swept and
free of debris both at the end of the burning season and prior to restarting the stove.
-
Clean the door glass to remove fly ash or tar deposits with a propriety glass cleaner or a
damp cloth and the ash from the fire box.
a)
CATALYSER
–
The 580EC2 only is fitted with a catalyser in the head of the stove above the
baffle system.
When building the stove
To install or replace/reinstall the catalyser; prior to fitting the box section baffle system; place
the 4 catalysers into place within the indents of the catalyser brick.