9
P
P
P
P
1
N
0 3
2
N
0 3
P
P
P
P
T
T
0 4
P
P
P
P
T
T
0 4
By SMS Command
To activate / cancel the “HOLD Command” by SMS you need to send SMS message as follows:
To Activate the HOLD command by SMS
To Cancel the HOLD command by SMS
-
PPPP
represent the 4 digit PASSWORD.
-
The letter “
N
” represent relay 1 or relay 2 or 3 for both relays.
The system will send an SMS to the sender informing bout the “Hold Command” of
both relays
for each
SMS command being sent, as follows: “
Confirming Relay 1 is Active ON
”
“
Confirming Relay 2 is No Longer Hold Active
”.
You can send one SMS to activate the Hold commands for both the relays as follows:
9999**03*31#
The SMS replay from the system is: “Confirming relay1 and relay 2 are ON Hold Active”
You can send one SMS to cancel the Hold commands for both the relays as follows:
9999**03*32#
The SMS replay from the system i: “Confirming relay1 and relay 2 are No Longer Hold Active”
8. How to limit the Talking Time
In program mode you can select and limit the talking time of the visitor.
The factory default limit time is 55 second.
The system will end each call (after the chosen “Talking Time”) by an announcement: “
END OF CALL
” .
Use the keypad and enter program mode and set the required talking time required as follows:
The letters “
T T
“ represent the time in seconds according to the table below:
Enter: 0 0 => for Zero talking time.
Enter: 5 0 => for 50 seconds talking time
(Default)
Enter: 6 1 => for 1 Minute talking time
Enter: 6 2 => for 2 Minutes talking time
Enter: 6 3 => for 3 Minutes talking time
;
Enter: 6 9 => for 9 Minutes talking time
Enter: 7 0 => for 10 Minutes talking time
Enter: 9 9 => for unlimited talking time.
The unit will confirm by Long Beep.
By SMS Command
To change the talking time by SMS command, send the SMS as follows:
The unit will confirm by SMS message to the sender as follows:
“The talking time was changed“
