2
INSTALLTION INSTRUCTIONS
1.
The SIM card
Make sure the power is OFF, and insert the SIM card with the gold pads facing down to the PCB.
Note !
Make sure that you insert or remove the SIM card only when the unit is disconnected from the Power
.
2.
Antenna
First run the Antenna’s cable via the back hole of the door station and connect it to the GSM socket in the unit.
(See page 2)
M
ake sure to install the antenna as high as possible and far from metal objects for better reception
and
do not cut or solder its cable
.
Note !
Do not install or attach the antenna on any metal surface
.
You can order special magnetic antenna for attachment to metal objects if required.
3.
Power
The unit can operate within
12V DC or AC/ 2Amp.
The unit is not polarity conscious. A long beep will be heard
to indicate power connection. Please wait
30 seconds
for the unit to log onto the GSM network and announce:
“
The unit is connected to the network
”.
If the unit could not log onto the network, it will announce:
“
The unit could not connect to the network
”.
In that case, please check the SIM card with your mobile phone and make sure that you can make a call on site.
4.
Outputs
The unit has two relay outputs, Relay-1 is related to the GSM access control and intercom and relay-2 is related
to the front keypad access control system. The relay-1 connections COM1 & N.O.1 can be used to activate the
electric latch of the pedestrian gate, and relay-2 connections COM2 & N.O.2 can be used to activate the
driveway gate.
You must bridge COM1 to COM2 and N.O.1 to N.O.2 if you are using only one relay output.
5.
Relays’ Function
You can select one out of the two functions (Pulse or Latch) for the each one of the internal relays of the unit.
The relays will trigger or be activated each time an authorized user calls the unit or keys in the correct 4-digit
pin-code, according to the function selected (Latch or Pulse) for each relay.
Steps of installation:
1.
Insert the SIM card.
2.
Connect the GSM antenna. Do not cut or shorten the antenna’s cable.
3.
Do not install or stick the antenna on to any metal surface or posts.
4.
Stick the antenna as high as possible to any brick wall or wooden fence or post.
5.
Use 12V AC/ DC to power supply (Min 2Amp) on terminals PWN1 and PWN2 – no polarity required.
6.
Use the relay-1 outputs Com.1 and N.O.1 for any electric lock/latch to open the pedestrian gate.
7.
Use the relay-2 outputs Com.2 and N.O.2 to trigger any control panel’s input to open the driveway gate.
8.
Bridge Com1 to Com2 and N.O.1 to N.O.2 if you use only one relay output
9.
Program the system as required according to the owner’s manual.
I M P O R T A N T !
IT IS A MUST TO SEAL THE BACK HOLES OF THE DOOR STATION
WITH SLICON TO PROTECT THE UNIT.
