Chengdu Ebyte Electronic Technology Co.,Ltd.
E106-xxxTxxS User Manual
Copyright ©2012–2023
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
13
5.6.2 Wireless transmission indication
In the general transmission mode:
Buffer empty: data from the internal 4096-byte buffer is written to the wireless chip (automatic subcontracting);
When AUX = 1, the user continuously initiates data less than 4096 bytes, which will not overflow;
When AUX = 0, the buffer is not empty: the data of the internal 4096 byte buffer has not yet been fully written to
the wireless chip and turned on transmission. At this time, the module may wait for the user data to end the timeout,
or is undergoing wireless subcontract transmission.
Continuous transmission mode:
Data in the buffer is "access and access", so the buffer size can be considered infinite.
[Note]: AUX = 1 does not mean that all the serial port data of the module is transmitted wirelessly, or the last packet
of data may be being transmitted.
AUX pin timing diagram when the module receives serial port data
5.6.3 Module is in the configuration process
The following states appears only for power reset, command reset, and exit hibernation mode (Mode 3).
Time iming diagram of AUX pins during the module self-test
5.6.4 Power initialization process
'T 1': initialization of MCAD (initialization time is 4~5ms);
'T 2' in the figure: represents the initialization of the RF chip configuration parameters (the initialization time is
about 500ms);
When the AUX pin is initialized, the GPIO peripheral configuration, as shown in the figure below.
