EBS LX2NB, Инструкция по установке и программированию, Страница: 32 / 57

LX2NB Manual v.1.3 Page 32 / 57
Note: where possible, use either the basic configuration of outputs (see
item 7.3.3.) or with an “Advanced outputs control”!
In particular, the basic configuration of existing options: “No GSM signal
(immediately after detection)” and “Dependent on state transitions from non-
active to active of one of the inputs” should not be used with their replacements
“[Off] GSM” and “[On] Input x”.
7.3.4.1. Output 1
These columns define which signals are to influence the status of a specific output.
Possible choices are:
o
Do Nothing – output status will be not changed (default action)
o
Turn on output – output will be permanently turned on
7.3.4.2. Turn on output temporarily – output will be turned on for an
amount of time specified by parameter 7.3.4.2 Time of output activation
o
Turn off output – output will be turned off
Press the [Reset] button to assign the action “Do Nothing” for each event.
The output state does not change if the current state of the output coincides with
the result of the action.