Installation instructions
ArgoDrive wheel change
AD-80.7
AD-100.12
AD-145.25
Article-Nr 14832 • 1.0 • en-us • Change • Release November 9, 2022 • page 10/11
ebm-papst St. Georgen GmbH & Co. KG • Hermann-Papst-Straße 1 • D-78112 St. Georgen
T49 (0) 7724 81-0 • Fax +49 (0) 7724 81-1309 • [email protected] • www.ebmpapst.com
9. Fit the slip hub.
10. Remove the two M3x12 screws with an Allen wrench
WAF2.5 and check whether the two latches fall onto the
slip hub again.
11. Tighten the six M6x40 cylinder head screws supplied to
16.5 Nm ± 1 Nm crosswise with a WAF5 hexagon socket.
Danger
Ensure brake function
If the two M3x12 screws have not been removed and
the two latches could not fall properly onto the slip hub
again, the brake is inoperative!
A brake test (see operating instructions) must
be performed before restarting.
5.1.6 Mounting the driving/steering system
Note
Further information can be found in the product's
operating instructions. You can find the relevant
current version of these operating instructions on our
homepage www.ebmpapst.com.
1. Mount the driving/steering system using the fastening
screws.
(depending on the installation position: attachment horizon-
tally on driving/steering system 4 screws; attachment verti-
cally on driving/steering system 8 screws)
5.2 Mechanical check following
installation
Perform a visual inspection to check for proper installation.
► Is the driving/steering system screwed evenly tight?
► Have all torques been checked?
► Have the two screws needed to raise the slip hub latches
been removed again?
If these questions can be answered with “Yes”, continue with
the next chapter.
5.3 Electrical hookup
Perform electrical hookup as described in the product's operat-
ing instructions.
Note
Further information can be found in the product's
operating instructions. You can find the relevant
current version of these operating instructions on our
homepage www.ebmpapst.com.
