3. Installation
3.3 Mounting
1. Insert the XV-303 into the mounting cutout.
2. Insert a holding bracket into the corresponding enclosure opening and tighten
the set screw until it comes into contact with the surface of the control panel, etc.
3. Repeat on the opposite side.
4. Follow steps 3 and 4 to insert the next holding bracket at a 90° angle to the last
one you inserted.
5. Repeat steps 3 and 4 until all holding brackets are installed.
6. Check that the Polyurethane foam gasket is in its correct, centered position all
around and adjust it if necessary.
7. Tighten the set screws in a criss-cross sequence with a torque of ≦ 0.1Nm (0.86
lb-in).
38
XV300
12/15 MN048017 EN www.eaton.eu
Содержание XV300 Series
Страница 1: ...Manual 12 15 MN048017 EN XV300...