Eaton XV300 Series, Руководство пользователя

Страница: 29 / 103

2. Safety instructions
2.3 Device-specific hazards
likely to occur.
Remove the SD card only when the XV300 is de-energized.
Before switching off the device, make sure that there are no programs writing
to the SD card.
CAUTION
SHORT-CIRCUIT HAZARD
If the XV300 Touch Panel is or has been exposed to environmental fluc-
tuations (ambient temperature, air humidity), condensation may form on or
inside it. As long as this condensation is present, there will be a short-circuit
hazard.
Do not switch on the XV300 Touch Panel when it has condensation in or on
it.
If the XV300 has condensation in or on it, or if the panel has been exposed
to environmental fluctuations, let the panel settle into the existing ambient
temperature before switching it on. Do not expose the XV300 Touch Panel
to direct thermal radiation from heating appliances.
CAUTION
UV LIGHT
Plastics will become brittle when exposed to UV light. This artificial aging
will reduce the XV300 unit's lifespan. Protect theXV300 unit from direct sun-
light and other sources of UV radiation.
CAUTION
POINTY, SHARP OBJECTS AND CORROSIVE LIQUIDS
When cleaning the XV300:
l
Do not use any pointy or sharp objects (e.g., knives).
l
Do not use aggressive or abrasive cleaning products or solvents.
Make sure that no liquids get into the XV300 unit (short-circuit hazard) and
that the XV300 unit is not damaged in any way.
CAUTION
INSTALLATION CUT-OUT
The mounting cutout must be located in a position that will not defeat the
purpose of stabilizing webs or other reinforcing elements in the control
panel. If necessary, reinforcing elements must be installed/added.
An IP65, Nema 4x or Nema 12 degree of protection will only be ensured if
there is sufficient stiffness, the device is properly mounted using the original
fixing material, and the gasket has a proper seat
l
Minimum sheet thickness of control panel panel where the device will be flush
mounted:
2 mm (0.08") ≦ d ≦ 5 mm (0.2")
CAUTION
When using commercially available peripheral devices (e.g., with the USB
port), it is important to keep in mind that their EMC interference immunity
parameters may render them unsuitable for use in industrial environments.
The USB ports (USB host and USB device) on the XV300 Touch Panel unit
are meant for maintenance work only.
XV300 12/15 MN048017 EN www.eaton.eu
29