Eaton XV200, Инструкция по эксплуатации

Страница: 40 / 60

5 Installation
5.4 Mounting
40
MICRO PANEL XV200
10/2011 MN04802007Z-EN www.eaton.com
4 Fit the supplied threaded pins in the retaining brackets beforehand.

The tips of the threaded pins must point towards the wider ends of the retaining brackets.
5 Fit the device from the front into the mounting cutout.
6 Clip on the retaining brackets in the recesses provided for them on the device as shown below and
fix the device by tightening the threaded pins until the front of the MICRO PANEL is flush with the
surface of the control cabinet at the fixing points.
Fig. 18 Groove for sealing strip (A)
Fig. 19 Threaded pin pre-fitted in a retaining bracket
CAUTION
Mechanical damage to the device
Tightening the threaded pins too tightly may damage the device.

Tighten threaded pins with a max. tightening torque of 0.1 Nm.

The positions of the retaining brackets depend on the mounting requirements.