23
Sonix 2Mx Technical Manual
SONIX 2MX TECHNICAL MANUAL
TM370 / A June 2022 www.eaton.com
9 Customisation
While every effort has been expended to make
the standard Sonix PA/GA system configuration,
this might not cover every requirement. To this end
customisation of the 2Mx, and any part of the Sonix
eco-system, should be discussed with your local Eaton
representative.
Certain features are considered as requiring
customisation by default.
9.1 IO audio and zoning
Currently the zoning for the Sonix Io unit is held within
the 2Mx firmware, please contact your local Eaton
representative to discuss options. This includes BGM
zoning.
9.2 Alarm Tones
Customisable alarm tones are possible, please contact
your local Eaton representative to discuss options.
Due to the way alarm tone audio is generated within
Sonix 350-d Amplifier, it is not possible to ‘mix’ multiple
tones simultaneously. Similarly, Sonix is not able to
provide volume adjustment to full volume alarm tones,
except by utilising attenuated alarm.
9.3 Important message over Alarm volume
The volume of Alarm Tone that is mixed into the
Emergency Speech broadcast is set to approximately
12dB lower than the normal Attenuated Alarm. This
value can be customised to one of the following: 1.1,
2.5, 4, 6, 8.5, 12 or 18dB.
ote:
N
Higher values limit the maximum level of Alarm Attenuate that
can be used before the volume difference is lost.
9.4 Program fault
The program fault, or minor fault, is a signal generated
from a sub-set of the available system faults and
transmitted out of the PA/GA system via the Sonix Io
unit.
The list of standard faults available is as follows:
•
Amp Line fault
•
Beacon Line fault *
•
Amp Data Fault
•
Hmi 1 Data Fault
•
Hmi 2 Data Fault
•
Beacon Data Fault *
•
IO Data Fault
•
Power Data Fault
•
Sync Data Fault
•
Global Data Fault
•
Amp Audio Fault
•
Hmi 1 Audio Fault
•
Hmi 2 Audio Fault
•
IO Audio Fault
•
Sync Audio Fault
•
Global Audio Fault
•
Amp Equipment Fault
•
Hmi Equipment Fault
•
Beacon Equipment Fault *
•
Power Equipment Fault
•
IO Equipment Fault
•
MS12 Equipment Fault
•
Pbx-Tu Equipment Fault
•
Matrix Fault
•
Sync Equipment Fault
Items marked with a * comprise all available beacon
faults and are considered standard output functionality.
ote:
N
This can be customised to support any combination of the listed
faults, please contact your local Eaton representative to discuss.
