3
CEAG Remote Display for Central Power Supply Systems
40071860348 October 2019 www.ceag.de
1 General Information
The remote display is an optional accessory of SelvGuard Low
Power System (LPS) and it’s meant to ease the notification of an
emergency lighting event from a remote location (i.e. a recepti-
on desk). It contains a back-lit graphical LCD with 128x64 pixels
resolution for increased clarity of information, 3 status LEDs
and a buzzer for acoustic reporting and notification.
Navigation through the menu is done via a 5 way joystick (left,
right, up, down, press).
It can be ordered separately (see below ordering details) and it
can be installed in any stage of the project.
Remote display is an optional hardware which allows control
and visualization of the system remotely. When correctly wi-
red, Remote display will work without additional configuration
(plug-and-play).
If Remote Display will be disabled at any time, reconnecting a
remote display to the system will not automatically enable
functionality. Functionality shall be enabled via Features menu
(4.6.2 Features).
Remote display provides a mirror display of SelvGuard local
display. Only the display logged in as Admin will operate at a
time. Normal operation will resume after logout or automati-
cally 5 minutes after back light time off (see section 4.2.8 Lo-
gout)
NOTE
Only one Remote display can be connected to one SelvGuard.
Figure 1 - Remote display
SG48-RC-LCD-30
Remote display for
SG48, 30° mount.
base
SG48-RC-LCD-55
Remote display for
SG48, 55° mount.
base
2 Connection of a remote display
Figure 2 - (1) Main display module; (2) 30°/55° inclined mounting base
The remote display is powered via the 24 V voltage supply of
the control unit inside the SelvGuard LPS.
ATTENTION!
Do not use an external supply for this module other than the
LPS!
NOTE
Observe national rules and regulations governing the indicating
and signalling behaviour when using a remote switch or a re-
mote indicator for emergency lighting systems.
1 General Information
