41
LCD touchscreen display programming
PRC-E Series Instruction Manual
MN014003EN August 2015 www.eaton.com
This will display the numeric keypad.
Tap the corresponding numbers to input the “From”
minutes required.
Tap the “Enter” button.
Tap the AM/PM dropdown to and choose the required time.
If the”Event” requires a relative start time, follow the
“Setting Relative Sunrise / Sunset Schedule” procedure to
enter proper “From” start time for the schedule.
otee:
N
Notice that the “Save” button in the top right corner
of the “Edit Schedule” screen did turn red, indicating
that there are some changes to the configuration in
this screen. The changes were accepted, but not yet
saved in the controller until the red “Save” button
is tapped.
Once the time schedule edits are complete, tap the red
“Save” button to save the changes. To leave the page
without saving changes, just tap the “Back” button.
The “Schedules” screen will now display the schedule with
an “Action”, “Days”, and a “From” time with no “Until” time.
Creating a backup schedule
Backup schedules are only used in networked systems
with a master device. In this case, the master device
will provide most of the system scheduling to maintain
centralized control. Master devices that can enable this
feature include the PRC5000 and the Ethernet Interface
Module (EIM). However, if the Network is down or the
master device has lost connection, the system will still
have a means of control. The backup schedules are part
of the distributed control feature of the Pow-R-Command
system. If a schedule is flagged as a “Backup” in the PRC-E
Series controller, it will only run when the connection to
the master device has been lost for an extended period of
time. If master device does not exist on the network, the
controllers will always be in backup mode.
To create a backup schedule, first create the required
schedule following the above procedures.
To specify the schedule as a “Backup”, tap the “Backup”
checkbox to add the checkmark.
Once the time schedule edits are complete, tap the red
“Save” button to save the changes
This schedule is now a backup schedule and will now
display the schedule with a “B” in the last column of the list
indicating that it is a backup schedule.