Eaton POWERWARE Plus 18, Руководство пользователя

Страница: 118 / 311

Upon power up. the UPS Digital Front Panel Display first sends the ID block.
the block is sent periodically every two minutes. If the Send Unrequested
Alarm Blocks flag is set (Alh). the ID block is sent periodically every two minutes and
the alarm block will be transmitted each a change with any of the UPS
This feature is Set by default The other blocks of data are sent once,
upon request
6.3.6 Block Descriptions
This section the data blocks in detail. They are the ID Block, the Alarm
Block, the Meter Block and the Alarm Block The data in each block is the same
for both ASCII and Binary computer modes.
ID Block
The block is to the UPS and the Meter and Alarm data blocks. Table
6-4 an overview of the ID block first piece of data is the number of
in the UPS and the number of software versions to follow. There is one
software version number for each of the Central Processing Units present in the
data block The order which they appear the table is fixed as shown. If particular
processor not installed then the software version number corresponding to the
is The are transmitted as the least significant
number first, followed by the byte.
The rating the next in the ID block followed by the number of output
the output angle and the byte count for the descriptive message. The
the name of the current UPS. Following
the message are the data block maps describing the information in the Meter and
The Meter map, shown in the table as bytes 41 through 109, describe what type. of data is
shown in the table as bytes 111 is the laat piece of data in the ID block.
N O T E :
The numbers in Table are not The actual byte
numbers depend on the type
of
UPS and the configuration.
EXIDE ELECTRONICS
6-21