Eaton Powerware 9910 UPS, Руководство по установке

Страница: 27 / 50

INSTALLATION
Eaton 9910 UPS and EBM Installation Guide (6000 VA Models)
S
P-164000007 Rev 1
19
connector
L6 − 30P
Communication
bay
USB
connector
RS − 232
connector
REPO
Ground
screw
P
Fan Six IEC 320 − C13
receptacles (Load segment 2)
Output
circuit breaker
EBM connector
Output
circuit
breakers
Four IEC 320 − C19
receptacles
(Load segment 1)
L6 − 30
inlet
Figure 2. The 9910-E67 UPS Rear Panel
Replacing an EBM
Follow the steps in this section if you are replacing an existing, installed
EBM with a new EBM. If you are installing a new UPS or EBM, continue
to “Rack Installation and UPS Internal Battery Connection” on page 21.
NOTE
DO NOT DISCONNECT the batteries while the UPS is in Battery mode.
An EBM can be replaced easily without turning the UPS off or
disconnecting the load.
If you prefer to remove input power to replace the EBM:
1. Press and hold the on/off button until the long beep ceases
(approximately 3 seconds), and then disconnect the UPS.
2. Wait 60 seconds while the internal processor shuts down before
you disconnect the EBM.