Eaton Powerware 9910 UPS, Руководство по установке

Страница: 29 / 50

INSTALLATION
Eaton 9910 UPS and EBM Installation Guide (6000 VA Models)
S
P-164000007 Rev 1
21
Rack Installation and UPS Internal Battery Connection
NOTE
If the UPS is pre-installed in a rack, you must first remove the protective shipping
bracket installed on the front of the UPS. See “Removing the Shipping Bracket from the UPS”
on page 34, then continue to Step 22 on page 26 to connect the internal batteries.
To install a UPS or EBM in a rack cabinet:
1. If your rack has round holes, continue to Step 2. Otherwise, skip to
Step 6.
2. Locate the four adapter plates that come in the rail kit.
3. Peel off the covering that protects the adhesive side of one adapter
plate, as shown in Figure 4.
Figure 4. Removing the Adapter Plate Adhesive
4. Align the adapter plate holes with the holes on one end of a rail.
Press firmly to adhere the adapter plate to the end of the rail, as
shown in Figure 5.
Figure 5. Attaching the Adapter Plates
5. Attach the remaining three adapter plates to the rails.