Eaton PowerPass 9PXPPDM1, Руководство пользователя

Страница: 42 / 62

STARTUP
Eaton 9PXTFMR5, 9PXPPDM2, 9PXTFMR11, and 9PXPPDM1 User's Guide S P-164000200 Rev 4
36
5. Ensure that the main circuit breaker on the 9PX PPDM or 9PX
Transformer is ON.
The equipment is powered by utility power, but not protected by
the UPS.
NOTE For 9PX PPDMs only. If the bypass switch is set to Bypass, the load is powered by
AC source, but still is not protected by the UPS.
C A U T I O N
The 9PX PPDM output circuit breaker (disconnect switch) disconnects power to the output on
the 9PX PPDM rear panel, but does NOT shut off power to the UPS (opening the upstream
protection would be required).
Batteries are recharging. An eight-hour recharge period is necessary
to get full backup time.
6. Press and hold the button until you hear the UPS beep
(approximately three seconds).
After the UPS is turned on, it conducts a self-test and enters
Normal mode. The
indicator remains on, indicating that power
is available to your equipment.
7. Confirm the UPS output voltage through the front panel and verify
that it matches the 9PX PPDM or 9PX Transformer output voltage.
For example, if the input to the UPS is 208V, then voltage selection
should be 208V. (For voltage settings and voltage selection
procedures for all models, see “Voltage Selection” on page 27.)
C A U T I O N
Failure to match the UPS output voltage may result in a hazardous condition, including
damage to the UPS or to the load.
8. Does you model use hardwired or plug-receptacle load output
connections for the equipment to be protected?
For models that use hardwired load output connections, this
procedure is completed.
For models that use plug-receptacle load output connections, go
the “Plug-Receptacle Connections.”