Eaton PowerPass 9PXPPDM1, Руководство пользователя

Страница: 17 / 62

EQUIPMENT INSTALLATION
Eaton 9PXTFMR5, 9PXPPDM2, 9PXTFMR11, and 9PXPPDM1 User's Guide S P-164000200 Rev 4
11
Installing the Rails
To install the rails in the rack:
1. Locate the rails and the mounting hardware in the rail kit accessory
box.
2. Locate the position where you will install the 9PX PPDM or 9PX
Transformer. (Install below the EBM if installed in this configuration,
or below the UPS if the EBM is not installed in this configuration.)
3. Place the rails on the inside of the rack posts with the cabinet
mounting flanges facing inside the rack. The
L (Left) or R (Right)
letter on the side of the rail should also face inside the rack (see
Figure 3).
4. Slide the rail to fit between the vertical rack posts.
5.
Secure each rail to the front and rear of the rack with two
M6
12 mm screws (see Figure 3).
FRONT
Rail-mounting
Screw Positions
REAR
Rail-mounting
Screw Positions
Figure 3. Attaching the Rails
6. Continue to the next section, “Installing the Cabinet.”