12
Green Motion EV smart breaker chargers
EV DIRECT CONNECT AND JUNCTION BOX KITS
www.eaton.com
EV DIRECT CONNECT AND JUNCTION BOX KITS INSTALLATION
Connect EV connector
C
• Connect the EV smart breaker charger and the EV connector and cordset .
• After the EV smart breaker charger is installed, attach the loadcenter or the panelboard deadfront .
• Energize the loadcenter or the panelboard . The EV smart breaker charger electronics should power
immediately, and the BlinkUp™ status LED will begin blinking . The indicator LEDs on the EV
connector will begin blinking . If no LED indicators are on, there is no power to the EV connector .
• Finally, ensure the EV smart breaker charger handle is in the ON position . Turn the EV smart breaker
charger on by moving the breaker handle from the OFF to the ON position .
STEP C-1
EV direct connect kit
EV connector wire color code:
1.
(GREEN)
EV connector ground
2. (BLUE)
+12 Vdc
3.
(ORANGE)
J1772 pilot
4.
(BLACK)
Line 2
5.
(RED)
Line 1
Figure 3
NOTE: The pilot conductor
(ORANGE)
is 1 inch shorter than
all other conductors in the EV connector cord assembly. This
difference in conductor lengths must be maintained to comply
with NFPA Article 625.19.
2
3
5
4
1
