7
EATON
EP Control for Medium Duty 72400 Piston Pumps Parts & Service 08-10-0003-EN-0901 September 2001
Step 5
Using a 3/4" open-end wrench,
remove each tube subassembly by
turning counterclockwise.
If only replacing the coil and tube
subassemblies, skip to Reassembly,
Step 12.
Step 6
Using a 5/32" hex key (or bit
socket), remove the six 10-24 hex
head cap screws.
Carefully lift the EP Control valve
assembly upward and slide the
assembly away from the pump to
disengage the feedback link from
the servo piston. Note which slot
the feedback link is assembled into.
Step 4
The two solenoid coils can be
removed by turning each solenoid
tube knob counterclockwise.
Remove the knob and associated
O-ring. Slide the coil off the tube
subassembly. Repeat for other coil.
Note:
Each coil is stamped with a
position number “1” and “2” and
the voltage “12V” or “24V”. There
are also numbers stamped on the
valve assembly indicating positions
#1 and #2. When reassembling the
coils, the numbers stamped on the
coil and valve assembly must
match. Refer to page 3.
Repair & Service
