Eaton 9395XC, Инструкция по установке и эксплуатации

Страница: 145 / 160

Eaton 9395XC UPS 1200kW/1200kVA, 1350kW/1350kVA or 1500kW/1500kVA 164001079—Rev 01 127
All power to the critical load is lost when the REPO switch is activated in the following step. You should use
this feature only when you want to de-energize the critical load.
NOTE The following instructions are for the Eaton-supplied REPO switch. If a customer-
supplied REPO switch is used, it may not activate in the same manner; refer to the
operating instructions provided with the switch.
To use the REPO pushbutton switch:
1. Firmly push the red pushbutton until it locks into place (see Figure 89 ). The switch latches into the
activated state.
The battery breaker or disconnect is tripped and the power module is turned off immediately without
asking for verification on all UPSs.
Do not attempt to restart the system after the Load Off until the cause of the shutdown has been identified and
cleared.
2. To deactivate the REPO pushbutton switch in preparation for restarting the UPS, insert the supplied key
and rotate clockwise until the red pushbutton releases (see
Figure 87 ). To remove the key, rotate the key
back to the vertical position.
3. Open systems MOBs.
4. Restart the UPSs by following the procedure in paragraph 7.4.1 Starting the UPS in Online Mode or
7.5.2 Starting the Distributed Bypass System in Bypass Mode .
Power is present inside the UPS cabinet until the upstream input feeder circuit breaker is opened.
AVERTISSEMENT!
L’intérieur de l’armoire de l’onduleur est alimenté jusqu’à ce que le disjoncteur du circuit d’alimentation en
amont soit activé.
UPS Operating Instructions