614-40099-00
29
1.
•
•
•
•
•
1.
2.
1.
2.
5.3 UPS Shutdown
To shut down the UPS:
Press the
button on the front panel for 3 seconds.
A confirmation message will appear.
When confirmed, the UPS starts to beep and shows a status of "UPS shutting OFF...". The UPS then transfers to
Standby mode, and the
indicator turns off.
5.4 Operating modes
The Eaton 5PX front panel indicates the UPS status through the UPS indicators located above the LCD screen.
Normal mode
When the green Sinewave symbol is illuminated, the UPS is providing protected AC power output. The UPS monitors and
charges the batteries as needed and provides power protection to your equipment.
Battery mode
When the UPS is operating during a power outage, the alarm beeps once every 10 seconds and the indicator illuminates
solid. The necessary energy is provided by the battery.
When the utility power returns, the UPS transfers to Normal mode operation while the battery recharges.
If battery capacity becomes low while in Battery mode, the audible alarm beeps once every 3 seconds.
This warning is approximate, and the actual time to shutdown may vary signifi cantly; gracefully shutdown all
applications on connected equipment due to imminent UPS shutdown.
When utility power is restored after the UPS shuts down, the UPS automatically restarts.
Low-battery warning
The
indicator illuminates solid.
The audio alarm beeps every three seconds.
The remaining battery power is low. Shut down all applications on the connected equipment because automatic UPS
shutdown is imminent.
End of battery backup time
LCD displays "End of backup time".
All the LEDs go OFF.
The audio alarms stops.
5.5 Return of AC Input Power
Following an outage, the UPS restarts automatically when AC input power returns (unless the restart function has been
disabled) and the load is supplied again.
5.6 Retrieving the Event log
To retrieve the Event log through the display:
Press any button to activate the menu options, then select Event log.
Scroll through the listed events.
5.7 Retrieving the Fault log
To retrieve the Fault log through the display:
Press any button to activate the menu options, then select Fault log.
Scroll through the listed faults.
