4
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
REquIRED ITEMS
Before you begin using the Eastwood TIG Welding System, make sure you have the following:
• Our TIG200 is supplied with the popular NEMA 50P plug, requiring a NEMA 50 receptacle. If a 220-240 VAC, 30 Amp outlet
is used a UL listed 30 Amp plug may be installed by a licensed and qualified electrician.
• The TIG200 will also operate on a 110-120 VAC 20 Amp circuit. To operate on this voltage it is necessary to connect the included
adaptor cord to the plug hard wired to the TIG200.
• A clean, safe, well-lit, dry and well-ventilated work area.
• A non-flammable, long sleeve shirt or jacket (Eastwood #12762L, XL, XXL).
• Heavy Duty Welding Gloves (#12590)
• An Auto Darkening Welding Mask (Eastwood #13203 or equivalent) to provide eye protection during welding operations.
NOTE:
MUST be a #11 lens or darker.
• A compressed gas cylinder containing 100% Argon (must be used when TIG welding and is available at any welding supply facility).
• Dedicated stainless steel wire welding brushes for each material to be welded.
• A dedicated fine grit synthetic stone grinding wheel or a Tungsten Sharpener.
POwER REquIREMENTS
The Eastwood TIG200 AC/DC is Voltage sensing; it will automatically operate on 110-120 VAC, 50/60 Hz., or 220-240 VAC, 50/60
Hz. Eastwood recommends at a minimum a properly grounded 110-120 VAC 50/60Hz., 20 Amp circuit or 220-240 VAC 50/60Hz.,
30 Amp circuit.
BEFORE YOu BEGIN
Remove all items from the box. Compare with list below to make sure unit is complete.
• TIG200 AC/DC Welder with NEMA50-P Plug
• Shielding Gas Regulator
• Shielding Gas Hose
• Ground Cable with Clamp (10’)
• TIG Torch (17 Series) which accepts industry standard cups, collets and collet bodies (14’)
• Foot Pedal for Amperage Control
• 110-120 VAC to 220-240 VAC Adaptor Plug
• Instruction Manual
• Hand Held Shield
• Hammer/Brush
• #7 Gas Nozzle (7/16”)
• #6 Gas Nozzle (3/8”)
• #5 Gas Nozzle (5/16”)
• Long Back Cap
• Short Back Cap
• 3/32” Collet Body
• 3/32” Collet
• 1/16” Collet
• 2.0mm Collet
• 2.0mm Red (Thoriated Tungsten)
