EASTMAN ETS-SLS-2, Инструкция по эксплуатации

Страница: 5 / 28

5
®
Encoder Track Installation
Proper installation of the encoder rail is very important for
accurate machine performance. The encoder track must be
level along its entire length. Drill (3) 7/32" diameter holes for
each 8' section of track, as shown. Mount encoder track to
table legs. When ALL sections of track are mounted, the
rubber encoder gear belt is then adhered IN ONE PIECE to
underside of track. Belt must be undamaged along its entire
length. If belt must be spliced, make sure that ribs of belt
remain at consistent spacing, otherwise microprocessor will
not function properly.
Spreading
Table
Non-Operator
Side
15.00"
48.00"
1.75"
1.50"
5.06"
47.53"
47.53"
.94"
.219 (7/32) Drill
For Encoder Track
& Cable Carrier
Encoder Assembly Installation
Mount Encoder Assembly on the rear frame as shown. The
encoder gear wheel must roll smoothly along encoder gear
belt. Fasten bracket with hardware provided. Adjust tension
so gear wheel remains in continuous contact with gear belt
as the SLS 2 moves.
Cable Carrier Installation
Before the Cable Carrier Kit can be installed the table legs on
the non-operator side must be modified. Drill two (2) 7/32
diameter holes in each table leg as shown. Locate the cable
carrier, trough, mounting brackets and mounting screws.
Assemble each section and mount to the table legs.
Mount the cable carrier between the two middle trough
sections. The SLS 2 requires 25 - 30 PSI compressed air.
Locate the air line on the cable carrier. Connect air line to
pressure regulator located on the non-operator side frame
and air supply.
Once the cable carrier is secured, connect the power plug
to the socket on the back frame. Check voltage rating with
electrical rating stamped on serial number plate. If compat-
ible, connect cable carrier cord to wall outlet.
Note: Voltage varying more than 10% (11V for 110V
machine, 22V for 220V machine) may damage your
system’s electronics.